-
v0.0.26 Pre-Release
released this
2023-04-07 22:26:14 +03:00 | 25 commits to master since this releaseFirst release-ready version.
Features:
- Measurements shown in Home Assistant:
- HRC & After heater percentage
- Unit operating state (as reported by unit)
- Room temperature at panel
- Temperature setpoint
- Circulation fan speed
- Outside air at unit
- Outside air 24h avg as reported by unit
- Intake air temperature after HRC
- Intake air humidity
- Supply air (after HRC & after heater)
- Heater element return water temperature
- Extract air temperature before HRC
- Waste air temperature (extract air after HRC)
- Extract air relative humidity %
- Extract air RH-% 48h avg
- HRC Efficiency ratio intake air
- HRC Efficiency ratio extract air
- Controllable settings via Home Assistant
- After heater element enable/disable
- Adaptive/manual circulation fan speed control mode toggle
- Speed settings (limits, manual fan speed) need to be set from device panel, this is a limitation of the Modbus interface on Enervent Pingvin
- Max heating/cooling mode toggle
- Overpressure (fireplace) mode toggle
- Manual ventilation boost mode toggle
- Change temperature target setpoint in 1 deg steps
- Built-in Prometheus exporter for metrics collection & retention
- All measurements not marked as "reserved" as unit manufacturer
- Go built-in statistics
See README.md for details on installation and configuration.
Place coils.csv and registers.csv in the same directory with the binary.Alerting support is not yet implemented, but planned.
Downloads
- Source Code (ZIP)
- Source Code (TAR.GZ)
-
coils.csv
1.9 KiB
-
enervent-ctrl-0.0.26.linux-arm32
12 MiB
-
enervent-ctrl-0.0.26.linux-arm64
12 MiB
-
registers.csv
53 KiB
- Measurements shown in Home Assistant: